Tempest x RepliCade has been designed in perfect one-sixth PlayScale to match your collectible figures, and fit perfectly on your bookshelf, bar, or desk.

These miniaturized sixth scale arcade machines are fully playable using the original controls, run the original game ROMs, and are officially licensed by the original manufacturers. Introducing New Wave Toy’s 12-inch PlayScale arcade machine replicas, RepliCade Amusements. If you have specific questions, just post them here.Recreate classic video arcade ambiance in your own home for a fraction of the cost of full-sized, vintage arcade cabinets. Replacing anything without knowing what you are doing is more likely to cause new problems than fix existing ones. You want to be doing step-by-step troubleshooting to figure out what's going on, and only replace parts when you have reason to suspect they're bad. Shotgun replacing parts will not fix your game, and guessing is not a repair strategy. So do some reading, do the things that have already been documented, and then post here if you have any specific questions.Īnd last but not least, don't go replacing parts or buying kits. Search for posts (not thread titles) with 'flipped test' by me, and you will find dozens of threads.Īlso note that any threads you find for other Atari vector games will also apply to Tempest in this case, as they're all very similar. Instructions here:Īlso, try powering the board up with the test mode switch already flipped on. If this is an original cab, you probably have multiple separate problems, so you have to break things down one system at a time and figure things out, starting with power, and then then the game board.Īlso, test your big blue to see if it is ok, as it will prevent the game board from booting if it is bad. You also should have a ROM burner to test the ROMs with, at a minimum. If you can't coin up the board and hear it playing blind, your board is not running. You want the game board playing blind before you worry about the monitor. But everything that can go wrong with a Tempest has been covered in a thread here somewhere.Īs Brian stated above, unplug the monitor and forget about it for now. So the more variations you search for, the more you'll find. Just search for posts by me with 'Tempest' in them, and/or search thread titles for 'tempest', 'tempest problem', 'tempest issue', etc.Īlso be aware that the search here is literal, so 'tempest problem' and 'tempest problems' will return different results. I've written several novels here about Tempest and 6100 repairs, and 99% of what's wrong with your game has already been covered in other threads, multiple times. Your first step is to use the Advanced Search page here to look up as many Tempest repair threads as you can find. If both x/y outputs are dead, what could be the cause? Is the board repairable? I replaced the flyback, but the same issue persists.ġ) Checked all fuses in the system (All good)Ģ) Checked over all caps I can see for any signs of damage (All look good, and the machine itself is in beautiful condition)ģ) Checked all test point voltages and it appears to be nominalĤ) Checked vector x/y outputs using oscilloscope: I am not reading any output from the vector x/y test loops. Guessing spot-killer circuit is dead? I was told (Incorrectly, I assume now, when I purchased it) that the Flyback was what needed to be replaced. The dot sometimes appears to change in color and intensity. There is no audio, though the start/select buttons do light up. It has noticeably burned a hole in the phosphor (before I bought it). The issue: The machine does nothing when powered on. I've got a Tempest Machine here that was 'supposed' to be a simple fix.

Tempest arcade game